Valves for instrumentation

It is recommended to be installed before a pressure gauge, a sensor or a pressure switch with a stop valve which allows :

  •  To remove it easily without interrupting the installation function.
  •  To control it with a calibrated pressure gauge during working.
  •  To protect it against possible overpressures.


Series Comments Photos Technical sheet
STOP NEEDLE VALVES – RP Construction in brass, steel or stainless steel with needle in stainless steel, stuffing box in PTFE and control wheel in plastic.

  • Inlet male G1/2”.
  • Outlet female by nut right/left G1/2”.


PDF
PRESS VALVES – RPO
  • Construction in brass.
  • Inlet male G1/4” or G1/2”.
  • Outlet female G1/4” or G1/2”.
  • Maximum working pressure : 10 bar.
--- PDF
MINIATURE VALVES Utilization for clean and filtered gas or liquid compatible with stainless steel.

  • Working pressure up to 14500 psi.
  • Working temperature : -40° to + 176 °F.
  • Coloured control wheel – colour to be indicated.
  • Connection as per request.
  • Minimum ID 1,5 mm.
PDF
OTHER REALIZATIONS Compact valves with pneumatic control for pressure up to 8700 psi.

  • Compact solenoid valves for pressure up to 5000 psi.
  • Cryogenic valves with pneumatic control or stainless steel bellow for pressure up to 6100 psi.
PDF




Aérodrome de Lognes - 77185 LOGNES - FRANCE - Tél : +33 160 17 87 50 - Fax : +33 1 60 17 87 35 - email : info@gie-polytechnics.fr

Un site internet réalisé par l'Agence Digeetal